E.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10

MIL-T-85703(AS)

4.6 Methods of inspection.

4.6.1 Operation. The tool and ancillary components shall be tested in

accordance with test method 1 (see 4.6.1.1). Defectives are those failing to

meet the requirements of 3.7.

4.6.1.1 Test method 1. Test method 1 shall consist of the following test

apparatus and test procedure:

Test apparatus

Power Pack Adapter (GFE), p/n A51S69315-15.

Electric power supply in accordance with 3.5.

Drive Tool Extension Assy, p/n 1167AS103-1.

Gun System Input Shaft (GFE), p/n BA226.

Test procedure

1. Connect the power pack adapter (GFE) to the tool output drive

adapter and the tool output drive shaft. Check for binding when connecting,

locking, and unlocking the power pack adapter.

2. Run the tool, with the power pack adapter connected, for 30

seconds in each direction. Check the tool for binding or chattering. Remove

the power pack adapter from the tool.

3. Install the drive tool extension assy to the tool output drive

shaft and then dismantle. Check any unusual force exerted in installing and

dismantling.

4. Insert the drive tool extension to the gun system input shaft

(GFE) and then disconnect. Check for binding when inserting and removing the

drive tool extension.

4.6.2 Performance. The tool output performance shall be tested in

accordance with test method 2A (see 4.6.2.1) for first article inspection and

test method 2B (see 4.6.2.2) for quality conformance inspection. Torque and

speed shall be measured at the tool output shaft. Defective are those

failing to meet the requirements of 3.8.

4.6.2.1 Test method 2A (first article). Test method 2A shall consist of

the following test apparatus and test procedure:

Test apparatus

1. Suggested test stand (see 4.6.2.3) or prony brake or power

absorbing dynamometer (with minimum torque rating at 75 ft-lb and maximum

speed rating over 500 rpm and with accessories to adapt tool outut shaft).